Novus AirGate-Modbus Bedienungsanleitung PDF herunterladen (Seite 10)

AirGate-Modbus

NOVUS AUTOMATION 10/22

CONFIGURATION MODES

AirGate-Modbus is configurable through DigiConfig software via USB interface, being necessary to put the device in

“setup mode”. To enter this mode, simply press the SETUP BUTTON, checking that the STATUS LED now flashes

slowly (approximately once per second). In “setup mode” the device stops behaving as a gateway from a Modbus

network and starts to accept the configurations. In the main screen of the DigiConfig software (Fig. 12) the following

configuration must be seen:

• Initial Address = 246

Fig. 10 - DigiConfig main screen

To edit the configurations of the AirGate-Modbus, after clicking the Search button, you must select it in the tree to the

left of the main screen.

To quit “setup mode“, you must press the SETUP BUTTON again, “Cancel”, or “Apply” a configuration. In this moment,

the device is reset and starts to operate according to the last applied configuration.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Keine Kommentare

Novus AirGate-Modbus Bedienungsanleitung Seite 10